If channels change unpredictably, or a double-digit channel (e.g., 44) appears as a single digit (4), the issue may be related to the IR (infrared) signal timing.
Step 1: Let the Channel Fully Change
-
Before pressing the
Channelbutton again, wait for the channel to fully change.
- Rapid button presses may cause errors in channel selection.
Step 2: Adjust the IR Signal Timing
Flipper is set to the fastest speed by default, so reducing the speed may help.
Decrease IR Speed (Slower Signal)
1 Press and hold
Device (STB or TV)
&
CH-
for
3 seconds until the light flashes
once.
2 This slows the signal
one level.
3 Try using Favorites after each level adjustment.
4 Repeat up to
5 levels total if needed.
Increase IR Speed (Faster Signal)
1 Press and hold
Device (STB or TV)
&
CH+
for
3 seconds until the light
flashes once.
2 This increases the signal
speed one level.
- If Flipper reaches the minimum or maximum speed, the light will flash twice to indicate no further adjustment is possible.