Step 1: Determine How You Change Channels
Ask yourself:
✔
Do you change channels with the TV remote?
→ Set TV Only Mode
✔
Do you change channels with a cable/Satellite Box (STB) remote?
→ Sync STB
Steps to Resolve:
1 Reset Flipper Remote
📌 Press and hold ADD until
the light turns solid, then
enter 954
✔ The light will blink out,
confirming reset
2 Set TV Control
📌 Press VOL
✔ If Volume works, go to
Step 3
✔ If not, then:
➡ Press and hold TV until the
light turns solid, then enter
the 4-digit TV code
➡ Test Power and Volume
3 Set STB / Cable Box Control
📌 Press CH
✔ If Channel works, setup is
complete
✔ If not, then:
➡ Press and hold STB until the
light turns solid
➡ Enter the 4-digit STB code
➡ Test Power and Channel
(No STB?)
📌 Press and hold TV until
solid, then enter 970 (TV
Only Mode)
Troubleshooting: If Red Light Does Not Work as Expected
1 Reset Individual Buttons
📌 Press and hold ADD until
solid, then enter
956 (light blinks out)
📌
Repeat for STB and TV buttons
2 Full Reset & Re-Sync
📌 Press and hold ADD until
solid, then enter
954 (light blinks out)
✔ Then re-sync TV and STB
using the steps above