Flipper is preset to many TVs and STBs.
Basic Set Up:
(1) Set TV: press VOL. If working, go to STB. If not, then: press and hold TV til the light turns solid, then enter the 4 digit code (test on/off and VOL);
*If you do not have a STB / Cable box, then: press and hold TV till solid, enter 970.
(2) Set STB* (STB = cable or satellite box): press CH. If the box changes channels, you are done. Go to Favs if desired. If CH does not work, then: press and hold STB till the light turns solid, then enter the 4 digit code (test on/off and CH);
*If you do not have a STB / Cable box, then: press and hold TV till solid, enter 970.
(3) Favorites: (if desired). Go to Manual "Favorites"
Troubleshooting:
If the red light does not work as expected, then reset as follows:
(1) Press and hold ADD till solid, then enter 956, light blinks out; Repeat with STB and TV buttons;
(2) Reset: press and hold ADD till solid, then enter 954, light blinks out. The sync, above.