Flipper is pre-programmed for many TVs and STBs (Cable/Satellite Boxes). Follow these simple steps to set up your remote.
Basic Setup
1 Set TV Control
📌 Press VOL
✔ If Volume works, go to
Step 2
✔ If not, then:
➡ Press and hold TV until the
light turns solid, then enter
the 4-digit TV code
➡ Test Power & Volume
(No STB? TV Only Mode)
📌 Press and hold TV until
solid, then enter
970
2 Set STB (Cable/Satellite Box) Control
📌 Press CH
✔ If channels change, setup
is complete ✅
✔ If not, then:
➡ Press and hold STB until the
light turns solid
➡ Enter the 4-digit STB code
➡ Test Power & Channel
(No STB? TV Only Mode)
📌 Press and hold TV until
solid, then enter
970
3 Set Favorites (Optional)
📌 If you want Favorites, go to the Manual "Favorites" Section
Troubleshooting
1 If the Red Light Doesn’t Work Correctly
📌 Press and hold ADD until
solid, then enter
956 (light blinks out)
📌
Repeat with STB and TV buttons
2 Full Reset & Re-Sync
📌 Press and hold ADD until
solid, then enter
954 (light blinks out)
✔
Re-sync TV & STB using steps above