v9 Flipper is preset to work a TV and STB / Cable box.
How do you change channels, with the TV branded remote, or with the cable / STB branded remote?
If the TV branded remote, then set Flipper for TV Only;
If the STB / cable branded remote, then sync Flipper to the STB / cable box.
QC Flow:
1) Reset to factory settings: press and hold ADD until the light turns solid, then enter 954;
2) Set TV: press VOL. If working, go to 3. If not, then: press and hold TV until the light turns solid, then enter the code for your device; test VOL;
- If no STB / cable box, then: press and hold TV till solid, then 970 (TV Only) - this maps the Channel buttons to the TV;
*3) Set STB: press CH. If working, then basic setup is complete. If not, then: press and hold STB until the light turns solid, then enter code for your device; test CH;